1973-1975 Chevrolet Caprice Convertible & 2dr Hardtop Quarter Window Seals New!

Description

Fits all 1973-1975 Caprice Convertible's & 2 door hardtop's
Rear Roll Up Seals - Quarter Window Leading Edge Seals
Attaches to the front edge of the rear quarter window - Fills the gap between the front and rear side windows
Sold by the pair
Brand New
Exact Replacement
15 Year Replacement Policy thru Metro Molded Rubber Products
In Stock and Ready to ship
Made in the USA
Have questions about this product or any other product you might be looking for?
Message us.
Hydro-E-Lectric has been providing quality made products since 1976.
We carry a full line of convertible top and power window parts for U.S. cars from 1946 through present day.
We ship WorldWide on a daily basis.
Contact us about combined shipping rates.
We accept Visa, MasterCard, American Express, Discover or PayPal.
READ CAREFULLY BEFORE YOU BEGIN INSTALLING QUARTER WINDOW SEALS! OLD QUARTER WINDOW SEALS should be replaced when they start to shrink, harden and crack. Wind and water can leak through. It's easy to give your car a better look with new quarter window seals. METRO's quarter window seals are the best you can buy! With steel cores and the smallest detail, don't settle for anything less! GENERAL HINTS: Heavily chromed channels may cause a very tight fit when installing quarter seals. Make sure you use a light lubricant to make your seal slide easily. A) REMOVE OLD SEALS: Remove your old seals. You may have to remove the door jamb to get to the seals. Remove any screws at the base of the old seal. Then, grab the old seal with pliers and pull down, using firm downward pressure with your other hand or with someone's help. Do not let the chrome come off the window! B) CLEAN OUT CHANNEL: Clean out any rust or debris with a small wire brush being careful not to scratch the chrome. You may put a strip of masking tape on the chrome before you start cleaning to protect it. Remove any old adhesive, using a release agent. Wipe the surface with a clean cloth. C) APPLY LUBRICANT: Apply a light lubricant or soapy water to the back of your new seal. If your model car did not have screws attaching the quarter seal, you will have to apply a small bead of adhesive to the inside of the channel. (Figure 10A). D) SLIDE SEAL ON: Slide the window seal starting at the bottom onto the channel. Replace the screws at the bottom of the base if necessary (Figure 10B) and reattach the door jamb.
For all your interior needs, visit allautointeriors on ebay